|ZPOOL-SCRUB(8)||System Manager's Manual||ZPOOL-SCRUB(8)|
begin or resume scrub of ZFS storage pools
Begins a scrub or resumes a paused scrub. The scrub examines all
data in the specified pools to verify that it checksums correctly. For
replicated (mirror, raidz, or draid) devices, ZFS automatically repairs any
damage discovered during the scrub. The
status command reports the progress of the scrub and
summarizes the results of the scrub upon completion.
Scrubbing and resilvering are very similar operations. The difference is that resilvering only examines data that ZFS knows to be out of date (for example, when attaching a new device to a mirror or replacing an existing device), whereas scrubbing examines all data to discover silent errors due to hardware faults or disk failure.
Because scrubbing and resilvering are I/O-intensive operations, ZFS only allows one at a time.
A scrub is split into two parts: metadata scanning and block scrubbing. The metadata scanning sorts blocks into large sequential ranges which can then be read much more efficiently from disk when issuing the scrub I/O.
If a scrub is paused, the
scrub resumes it. If a resilver is in progress, ZFS
does not allow a scrub to be started until the resilver completes.
Note that, due to changes in pool data on a live system, it is possible for scrubs to progress slightly beyond 100% completion. During this period, no completion time estimate will be provided.
- Stop scrubbing.
- Pause scrubbing. Scrub pause state and progress are periodically synced to
disk. If the system is restarted or pool is exported during a paused
scrub, even after import, scrub will remain paused until it is resumed.
Once resumed the scrub will pick up from the place where it was last
checkpointed to disk. To resume a paused scrub issue
- Wait until scrub has completed before returning.
- Example 1: Status of pool with ongoing scrub:
status... scan: scrub in progress since Sun Jul 25 16:07:49 2021 403M scanned at 100M/s, 68.4M issued at 10.0M/s, 405M total 0B repaired, 16.91% done, 00:00:04 to go ...
- Metadata which references 403M of file data has been scanned at 100M/s, and 68.4M of that file data has been scrubbed sequentially at 10.0M/s.
|July 25, 2021||OpenZFS|